Harley-Davidson Specific Tools

129 products

Shop the range of aftermarket motorcycle wheel products at Pro Class Custom Parts.

$501.99

Features & Benefits:- * Provides for simple, fast and accurate fuel pressure checks. * Quickly diagnoses: Loss of power, poor fuel economy, hesitation & stalling * Fits 2001 and newer fuel...

JIMS

$505.99

Features & Benefits:- * Suggested additional purchase, Timken Bearing # SS31-4013 Tech Tips:- * May cause a slight increase in engine noise * Replaces OEM # 34822-08 MFR PART No: 956 ROLLIES...

JIMS

$529.99

* Inner collar will retain wrench to nut for safer work * Remove hex nut from end of main drive gear that secures the rear drive transmission pulley * Extra-long two-piece design * Made in the U.S...

JIMS

$516.99

Features & Benefits:- * Fits Twin Cam Softail 2000-2006, Dyna 1999-2005 & Touring 1999-2006. * Used to remove inner cam bearing without damaging the crankcase. * Tool is also designed to k...

Sold Out

JIMS

$491.99

JIMS Wrist Pin Clip Remover and Installer for Twin Cam Pistons * Use tools to easily remove and install wire type wrist pin clips without damage to the piston MFR PART No: 769 ROLLIES PART No: J...

JIMS

$482.99

* Presses in the inner cam bearing * Designed to press from letter side of the inner cam bearing by putting all the pushing pressure to the very outer wall of bearing shell * Eliminates any damage...

JIMS

$489.99

* Lock your transmission pulley for removing or installing pulley nut * Fits OEM & Aftermarket 5 & 6 speed transmissions. * Made in the U.S.A. Tech Tips:- * Does NOT fit Sportster Models (...

JIMS

$473.99

* Made in the U.S.A. MFR PART No: 1414 ROLLIES PART No: JM-1414

JIMS

$433.99

Bolts to case and locks pinion gear, necessary to torque the pinion nut. Use on Big Twin 1954-1999 single-cam engines. MFR PART No: 2237 ROLLIES PART No: JM-2237

JIMS

$447.99

Swing arm bearings must be installed and aligned accurately to avoid unsafe handling and ensure control of the motorcycle. Both drive side and brake side bearings, which are at different depths, ...

Sold Out

JIMS

$448.99

This is a must use tool for removal or installation of retaining ring otherwise you run the risk of developing a fuel leak. Tool safely removes the retaining ring holding the fuel pump. Use for qu...

FEULING

$413.99

* This pressure test tool is a must for any Twin Cam engine builder. Bench test the camplate before installation, cycle the pressure relief valve testing operation assuring the valve moves freely,...

$416.99

S&S now offers an economical way to hold an engine on the work bench, for shipping, or for display. S&S engine stands are constructed of heavy gauge stamped steel with S&S laser cut in...

JIMS

$427.99

Features & Benefits:- * Fits all H-D Models. * Supplied with six bands. * Works with piston sizes from 2-7/8″ to 4-3/8″. * Fine-tooth ratcheting motion will compress the bands in small increme...

$419.99

S&S offers an economical way to hold an engine on the work bench, for shipping, or for display. S&S engine stands are constructed of heavy gauge stamped steel with S&S laser cut in bot...