Harley-Davidson Specific Tools

129 products

Shop the range of aftermarket motorcycle wheel products at Pro Class Custom Parts.

$200.99

Features & Benefits:- * Use with the Clutch Spring Compressor Tool # JM-38515-90. Tech Tips:- * Will Not Fit XR1200. Proudly Made in the USA by JIMS ! MFR PART No: 38515-91 ROLLIES PART No: ...

DAYTONA TWIN TEC

$1,770.99

FITMENT: Softail 2011-2020 inc. M8 2018-2020 but NOT 2021up Dyna 2012-2017 Touring 2014-2020 inc. M8 2017-2020 but NOT 2021up Sportster 2014-2021 Twin Scan 4 ABS Low Cost Scan Tool for 2011up Harl...

TECHNO RESEARCH TUNER

$210.99

Kit Includes: 25 Rivnuts, 25 screws and 25 copper washers MFR PART No: TR200045 ROLLIES PART No: TR200045

JIMS

$200.99

Features & Benefits:- * Designed to unload the pressure on the primary and secondary chain tensioners to assemble and disassemble cams. * Also checks spring loads on chain tensioners * Includ...

FEULING

$254.99

This tool allows you to test all Twin Cam and M8 piston cooling jets. Leaking piston cooling jets can send too much oil into the crankcase, causing high engine oil sump levels. #FE-9071 is a comp...

JIMS

$216.99

The new M8 engine uses different wrist pins compared to other Harley-Davidson® engines. This tool quickly and easily removes the wrist pins in these new engines. To reduce cost and save tool bo...

Sold Out

JIMS

$223.99

Features & Benefits:- * Short Socket. * Designed to Remove, Install & Properly Tighten the Front Final Drive Sprocket/Pulley Nut. * Although the much longer Big Twin socket will fit the nu...

JIMS

$203.99

Features & Benefits:- * Replacement 25mm Puller Only. Proudly Made in the USA by JIMS ! MFR PART No: 1042-8 ROLLIES PART No: JM-1042-8

JIMS

$221.99

Suggested additional Purchase JM-906 MFR PART No: 970 ROLLIES PART No: JM-970

NAMZ CUSTOM CYCLE PRODUCTS

$200.99

MFR PART No: NMTRT-01 ROLLIES PART No: NMZ-NMTRT-01

Sold Out

KRAUS MOTO

$201.99

Features & Benefits:- The Kraus Cartridge Seal Head Driver Tool tool is necessary for Ohlins fork rebuilding and cartridge installation for Ohlins FKS 508 cartridges. This tool uses a 3/8in. d...

JIMS

$812.99

The Harley-Davidson® Milwaukee Eight crankcase is a robust and sealed engine case when assembled correctly. In order to perform any type of lower end service or performance work, it is necessary t...

JIMS

$763.99

MFR PART No: 96830-51 ROLLIES PART No: JM-96830-51

FEULING

$483.99

FEULING oil pump pressure test tool for Feuling M8 oil pumps, ONLY fits FEULING oil pumps, does not fit factory HD oil pumps. Bench test the FEULING Milwaukee Eight oil pumps, cycle the pressure r...

JIMS

$715.99

Fitment Note: The 06-pres Dyna, 07-Pres Twin Cam Models. The bearing race is installed from factory with RED Locktite along with the trans pulley nut. This has been causing some problems. The tw...