Harley-Davidson Specific Tools

133 products

Shop the range of aftermarket motorcycle wheel products at Pro Class Custom Parts.

$248.99

Features & Benefits:- * Replacement 25mm Puller Only. Proudly Made in the USA by JIMS ! MFR PART No: 1042-8 ROLLIES PART No: JM-1042-8

JIMS

$235.99

Suggested additional Purchase JM-906 MFR PART No: 970 ROLLIES PART No: JM-970

NAMZ CUSTOM CYCLE PRODUCTS

$205.99

MFR PART No: NMTRT-01 ROLLIES PART No: NMZ-NMTRT-01

KRAUS MOTO

$204.99

Features & Benefits:- The Kraus Cartridge Seal Head Driver Tool tool is necessary for Ohlins fork rebuilding and cartridge installation for Ohlins FKS 508 cartridges. This tool uses a 3/8in. d...

JIMS

$994.99

The Harley-Davidson® Milwaukee Eight crankcase is a robust and sealed engine case when assembled correctly. In order to perform any type of lower end service or performance work, it is necessary t...

JIMS

$936.99

MFR PART No: 96830-51 ROLLIES PART No: JM-96830-51

FEULING

$590.99

FEULING oil pump pressure test tool for Feuling M8 oil pumps, ONLY fits FEULING oil pumps, does not fit factory HD oil pumps. Bench test the FEULING Milwaukee Eight oil pumps, cycle the pressure r...

JIMS

$876.99

Fitment Note: The 06-pres Dyna, 07-Pres Twin Cam Models. The bearing race is installed from factory with RED Locktite along with the trans pulley nut. This has been causing some problems. The tw...

Sold Out

JIMS

$942.99

The M8 engine returns to the single camshaft design, which requires a new tool for correct and accurate replacement of the camshaft inner needle bearing. Compared to the OEM tool, this remover u...

JIMS

$923.99

* Use on all Twin Cam, Dyna 2006 & Big Twin 2007-2017. * Used to remove inner cam bearing without damaging the crankcase * Tool is also designed to keep rollers from falling into the crankcase...

Sold Out

JIMS

$916.99

Use to Remove & Install the main drive gear. Also installs the main bearing without removing transmission case this tool will NOT damage bearing or main drive gear during install. Tech Tip:- *...

JIMS

$772.99

When changing valve springs for performance upgrades, or simply replacing a leaking valve seal, it is necessary for the technician to completely remove the cylinder head from the engine. This adds...

Sold Out

JIMS

$771.99

When it comes to servicing the inner primary bearing and seal, do it the JIMS way. This American made tool drives the bearing and seal perpendicular to the case without an arbor press. JIMS has be...

JIMS

$756.99

A tool that every engine builder needs. This tool properly tests the pressure rating of each piston oiler jet before you final assemble your engines. MFR PART No: 730 ROLLIES PART No: JM-730

JIMS

$720.99

* Fits Big Twin 1955-2002 including Twin Cam & Aftermarket Important Note: You must use a 94660-37A socket tool as noted above. +03’up also purchase JM-973 MFR PART No: 97225-55 ROLLIES PAR...