Harley-Davidson Specific Tools

134 products

Shop the range of aftermarket motorcycle wheel products at Pro Class Custom Parts.

Sold Out

JIMS

$994.99

N/A

FEULING

$583.99

FEULING oil pump pressure test tool for Feuling M8 oil pumps, ONLY fits FEULING oil pumps, does not fit factory HD oil pumps. Bench test the FEULING Milwaukee Eight oil pumps, cycle the pressure r...

JIMS

$931.99

Fitment Note: The 06-pres Dyna, 07-Pres Twin Cam Models. The bearing race is installed from factory with RED Locktite along with the trans pulley nut. This has been causing some problems. The two...

JIMS

$924.99

Use to Remove & Install the main drive gear. Also installs the main bearing without removing transmission case this tool will NOT damage bearing or main drive gear during install. Tech Tip:- *...

JIMS

$530.99

A tool that every engine builder needs. This tool properly tests the pressure rating of each piston oiler jet before you final assemble your engines.

JIMS

$495.99

Features & Benefits:- * Used to remove & install camshafts & bearings. * Provides precision alignment of camshafts in the support plate. Tech Tips:- * Will Not Fit Dyna 2006. Proudly M...

Sold Out

JIMS

$681.99

Features & Benefits:- * All Milwaukee-Eight engines (Softail and Touring) incorporate balancers to reduce vibration. * JIMS has now developed a balancer bearing installer, which can be used i...

Sold Out

JIMS

$632.99

Features & Benefits:- * Fits 4 & 5 Speed Models * Heavy-Duty thick wall tube. * Extra long two piece design, inner collar will retain wrench to nut for safer service work. * 1-7/8″ hex. *...

JIMS

$602.99

Features & Benefits:- * Suggested additional purchase, Timken Bearing # SS31-4013 Tech Tips:- * May cause a slight increase in engine noise * Replaces OEM # 34822-08

JIMS

$631.99

* Inner collar will retain wrench to nut for safer work * Remove hex nut from end of main drive gear that secures the rear drive transmission pulley * Extra-long two-piece design * Made in the U.S...

JIMS

$676.99

Features & Benefits:- * Fits Twin Cam Softail 2000-2006, Dyna 1999-2005 & Touring 1999-2006. * Used to remove inner cam bearing without damaging the crankcase. * Tool is also designed to k...

Sold Out

JIMS

$587.99

JIMS Wrist Pin Clip Remover and Installer for Twin Cam Pistons * Use tools to easily remove and install wire type wrist pin clips without damage to the piston

Sold Out

JIMS

$608.99

* Lock your transmission pulley for removing or installing pulley nut * Fits OEM & Aftermarket 5 & 6 speed transmissions. * Made in the U.S.A. Tech Tips:- * Does NOT fit Sportster Models (...

Sold Out

JIMS

$538.99

Bolts to case and locks pinion gear, necessary to torque the pinion nut. Use on Big Twin 1954-1999 single-cam engines.

JIMS

$556.99

Swing arm bearings must be installed and aligned accurately to avoid unsafe handling and ensure control of the motorcycle. Both drive side and brake side bearings, which are at different depths, ...