Jims

142 products

JIMS motorcycle tools are available for adjusting clutches, installing exhaust gaskets, removing camshafts, aligning ignitions and much more. Browse the range below!

Sold Out

JIMS

$8,352.99

The JIMS FAT 6 transmission is a rock solid, “bolt-in” performance upgrade for the stock, O.E.M. 6-speed transmission. Starting with our raw material, JIMS designed FAT 6 gears to be manufactured ...

JIMS

$329.99

Features & Benefits:- * Remove & Install. Proudly Made in the USA by JIMS ! MFR PART No: 5518 ROLLIES PART No: JM-5518

JIMS

$334.99

Features & Benefits:- * Remove & Install. * The shifter shaft bushing cannot be pressed through to remove it requiring this JIMS specialty tool. This new JIMS tool is designed to remove th...

JIMS

$1,478.99

Its common knowledge that heat is one of an engines worst enemies. In developing the JIMS cylinder head cooler, JIMS had to sacrifice a few motors for the cause. We tested worst case scenarios b...

JIMS

$573.99

* Made in the U.S.A. MFR PART No: 1414 ROLLIES PART No: JM-1414

JIMS

$543.99

This is a must use tool for removal or installation of retaining ring otherwise you run the risk of developing a fuel leak. Tool safely removes the retaining ring holding the fuel pump. Use for qu...

JIMS

$336.99

MFR PART No: 943 ROLLIES PART No: JM-943

JIMS

$336.99

MFR PART No: 944 ROLLIES PART No: JM-944

JIMS

$206.99

FXD Ignition Switch / Fork Lock Tool This tool will remove or install the ignition / fork lock, switch face plate which secures the ignition switch by the neck frame area on all Dyna models. MFR...

JIMS

$711.99

Features & Benefits:- * Installs the two cam needle bearings on Twin Cam 88 motors -perfectly aligns the shaft bore for a precise press fit. * Also installs the two inner cam bearings on Twin ...

Sold Out

JIMS

$933.99

The M8 engine returns to the single camshaft design, which requires a new tool for correct and accurate replacement of the camshaft inner needle bearing. Compared to the OEM tool, this remover u...

JIMS

$914.99

* Use on all Twin Cam, Dyna 2006 & Big Twin 2007-2017. * Used to remove inner cam bearing without damaging the crankcase * Tool is also designed to keep rollers from falling into the crankcase...

JIMS

$625.99

Features & Benefits:- * Fits Twin Cam Softail 2000-2006, Dyna 1999-2005 & Touring 1999-2006. * Used to remove inner cam bearing without damaging the crankcase. * Tool is also designed to k...

JIMS

$867.99

Fitment Note: The 06-pres Dyna, 07-Pres Twin Cam Models. The bearing race is installed from factory with RED Locktite along with the trans pulley nut. This has been causing some problems. The tw...

Sold Out

JIMS

$763.99

When it comes to servicing the inner primary bearing and seal, do it the JIMS way. This American made tool drives the bearing and seal perpendicular to the case without an arbor press. JIMS has be...