Tools & Supplies

155 products

Shop the range of aftermarket motorcycle tools and supplies at Pro Class Custom Parts.

$285.99

This tool allows you to test all Twin Cam and M8 piston cooling jets. Leaking piston cooling jets can send too much oil into the crankcase, causing high engine oil sump levels. #FE-9071 is a compl...

JIMS

$254.99

The new M8™ engine uses different wrist pins compared to other Harley-Davidson® engines. This tool quickly and easily removes the wrist pins in these new engines. To reduce cost and save tool bo...

Sold Out

JIMS

$285.99

Features & Benefits:- * Short Socket. * Designed to Remove, Install & Properly Tighten the Front Final Drive Sprocket/Pulley Nut. * Although the much longer Big Twin socket will fit the nu...

$250.99

* Size range is 14.8mm to 18.0mm (13/16″) * Narrow Stainless steel 7mm wide band provides concentrated seal compression * 360 degree Stepl design with no gaps on inner surface * Specially formed s...

JIMS

$265.99

Features & Benefits:- * Replacement 25mm Puller Only. Proudly Made in the USA by JIMS !

$251.99

A high-quality upgrade from an OEM toolkit for motorcycle, ATV, and snow, the M1 provides combination wrenches, an adjustable wrench, locking pliers, 6-in-1 screwdriver, spark plug wrench, tire ga...

NAMZ CUSTOM CYCLE PRODUCTS

$212.99

N/A

KRAUS MOTO

$208.99

Features & Benefits:- The Kraus Cartridge Seal Head Driver Tool tool is necessary for Ohlins fork rebuilding and cartridge installation for Ohlins FKS 508 cartridges. This tool uses a 3/8in. d...

JIMS

$1,009.99

The Harley-Davidson® Milwaukee Eight crankcase is a robust and sealed engine case when assembled correctly. In order to perform any type of lower end service or performance work, it is necessary t...

Sold Out

JIMS

$994.99

N/A

FEULING

$583.99

FEULING oil pump pressure test tool for Feuling M8 oil pumps, ONLY fits FEULING oil pumps, does not fit factory HD oil pumps. Bench test the FEULING Milwaukee Eight oil pumps, cycle the pressure r...

JIMS

$931.99

Fitment Note: The 06-pres Dyna, 07-Pres Twin Cam Models. The bearing race is installed from factory with RED Locktite along with the trans pulley nut. This has been causing some problems. The two...

JIMS

$924.99

Use to Remove & Install the main drive gear. Also installs the main bearing without removing transmission case this tool will NOT damage bearing or main drive gear during install. Tech Tip:- *...

JIMS

$530.99

A tool that every engine builder needs. This tool properly tests the pressure rating of each piston oiler jet before you final assemble your engines.

JIMS

$495.99

Features & Benefits:- * Used to remove & install camshafts & bearings. * Provides precision alignment of camshafts in the support plate. Tech Tips:- * Will Not Fit Dyna 2006. Proudly M...